I was fortunate enough to get asked to take a look at a Quantum board. Had not worked on one, but was willing to give it a shot!
First I had to build up my bench harness which connects into my Atari Bench Power Test Rig.



I start with just the power connections and verify and recheck them before connecting to a PCB. I can usually start working on the board with just power to start. Once I determine I need controls I wire the small 15 pin Molex to match the appropriate bench controller. Finally once a vector game is running on the scope – I wire up the large 15pin connector for my bench 6100.
Board #1 – Quantum
Reported with Graphics issues. Powering it on, board was watchdogging. I had already verified all the ROMs and tested all the RAM (off board), cleaned legs, DeoxIT, etc.
Quantum uses a 68000 processor, so no ability to plug in with the FPGA Catbox and verify bus operations. Spent some time checking the data and address busses, but they all seamed like they were working. It appeared the address decoder PROM@1C was not signaling on pin 12. I burned a replacement GAL chip, but no joy. I was still learning the board and a little research showed that even the Pokey’s could prevent booting.. Pulled the originals and replaced them.. board booted! Put them both back, board booted?!
Dirty sockets? I’m going to replace them.

I haven’t done all the testing yet, It doesn’t seem to be saving high scores.
Board works!
Board #2 – In for Repair
Been a while since I’ve worked on one. Owner asked if I could get the Quantum, Amplifone and an ARII going before Thanksgiving for a show he wanted to bring this all too.. I said I would give it a shot!

Quantum is a very nice looking board.

I initially plugged it and and it was stone dead.. In those cases – I tend to do board maintenance first. Clean chip legs and Deoxit. Because this machine has a 68000 CPU – there is no plugging in with a tester (at least that I own) and checking ROM and RAM. I individually tested the ROM on the bench during the clean.
Once that was done I probed around the board with the scope. The watchdog was getting cleared and the CPU was not resetting.. During this time I determined the vector circuit was dead. Probing all through it, nothing was going on. It was pretty strange to see the board in this state.
I’d looked an chips and they all appeared to be fine via comparitor..
Finally I decided to just swap the CPU – board came to life. The original CPU was absolutely working. I could clearly see address lines and data. Pulling the first ROM got it watchdogging. It was running.
But something was off..

Board works!
[…] fixing traditional ones. Quantum technology in repair involves precision tools and understanding quantum circuits. Staying updated helps you know how these innovations shape the future of repair and […]